Table of Contents
Advertisement
debug Commands
debug ip rip
undebug ip rip
show Commands
Copyright © 2010, Juniper Networks, Inc.
The debug commands provide information about the following RIP items:
General events, such as creating a RIP process or removing RIP from an interface
Routing events, such as when two RIP routers exchange routes
Use to display information about selected RIP events. This command has many
keywords that allow you to specify a variety of RIP events.
You can set the level of severity for the events you want displayed; specify the desired
descriptive term or a corresponding number (0–7).
You can set the verbosity of the messages you want displayed: low, medium, high.
Example
host1#debug ip rip events
Use the no version to cancel the display of any information about the designated
variable.
See debug ip rip
Use to cancel the display of information about a selected event.
The same RIP variables can be designated as in the debug ip rip command.
Example
host1#undebug ip rip events
There is no no version.
See undebug ip rip
Use the show commands to monitor the following types of RIP information:
Configuration
IP-related information
Global counters
Counters for a specified network
Statistics
You can set a statistics baseline for RIP interfaces by using the baseline ip rip command.
You can specify a VRF instance for the show ip rip commands. You can use the output
filtering feature of the show command to include or exclude lines of output based on a
text string you specify. See JunosE System Basics Configuration Guide, for details.
Chapter 4: Configuring RIP
225
Advertisement
Table of Contents
