Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 134

Software for e series broadband services routers ip, ipv6, and igp configuration guide
Table of Contents

Advertisement

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
110
TCP Connection Event Log (most recent at bottom)—Event log for the TCP
connection. It shows the last 32 events that occurred on the connection. The most
recent event is at the bottom of the list. This is per-connection data.
TCPS_ELOG_PRU_ATTACH
TCPS_ELOG_PRU_BIND
The following events can be recorded:
Fast Timeout
2MSL Timeout
Retransmit Timeout
Persist Timeout
Received FIN packet
Received SYN packet
Received Retransmission
Transmit a FIN packet
Transmit a SYN packet
Retransmit a packet
Did a PRU_ATTACH
Did a PRU_DETACH
Did a PRU_BIND
Did a PRU_LISTEN
RST/SYN-Ack DoS Protection—Specifies when this function is enabled
Did a PRU_CONNECT
Did a PRU_CONNECT2
Did a PRU_DISCONNECT
Did a PRU_ACCEPT
Did a PRU_SHUTDOWN
Did a PRU_RCVD
Did a PRU_SEND
Did a PRU_ABORT
Did a PRU_SENSE
Did a PRU_RCVOOB
Did a PRU_SENDOOB
Did a PRU_SOCKADDR
Did a PRU_PEERADDR
The keepalive timer popped. An 8-bit argument
that describes how the timer was handled:
Ignored because the session was not
established (that is, not in the OPEN state)
Ignored due to idle-timeout considerations
A packet was sent
Ignored because the connection did not have
the keepalive option set OR the connection
was in the process of closing
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents