Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
Displaying CLNS
baseline clns
390
host1#undebug isis adj-packets
There is no no version.
See undebug isis
You can display the following information related to the CLNS protocol:
CLNS information about interfaces
Information about router adjacencies
Information about ES and IS neighbors
Protocol-specific information for each routing process
Information about CLNS packets
Global CLNS configurations
You can set a statistics baseline for CLNS using the baseline clns command.
Use to set a statistics baseline for CLNS.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Use the optional interface-specifier parameter to specify an interface; otherwise the
command sets a baseline for all interfaces.
You cannot set a baseline for groups of interfaces.
When baselining is requested, the time since the last baseline was set is displayed in
days, hours, minutes, and seconds.
Use the optional delta keyword with the show clns traffic command to specify that
baselined statistics are to be shown.
Example
host1#show clns traffic detail
IS-IS: Baseline last set 0 days, 0 hours, 1 minutes, 41 seconds
IS-IS: Corrupted LSPs: 0
IS-IS: L1 LSP Database Overloads: 0
IS-IS: L2 LSP Database Overloads: 0
IS-IS: Area Addresses Dropped: 0
IS-IS: Attempts to Exceed Max Sequence: 0
IS-IS: Sequence Numbers Skipped: 6
IS-IS: Own LSPs Purged: 1
IS-IS: System ID Length Mismatches: 0
IS-IS: Maximum Area Mismatches: 0
Interface: atm2/1.3
IS-IS: Baseline last set 0 days, 0 hours, 1 minutes, 43 seconds
IS-IS: Protocol PDUs (in/out): 32/36
IS-IS: Init Failures: 0
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
