Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
380
lspid—Link-state protocol ID in form xxxx.xxxx.xxxx.yy-zz
hostname—Link-state database information for the specified hostname
detail—Detailed link-state database information; if this option is not specified, a
summary display is provided
l1—Level 1 routing link-state database
l2 —Level 2 routing link-state database
level-1—Level 1 routing link-state database
level-2—Level 2 routing link-state database
Each option can be entered in an arbitrary string within a single command entry.
Field descriptions
LSPID—LSP identifier
LSP Seq Num—Sequence number for the LSP. Enables other routers to determine
if they have received the latest information from source.
LSP Checksum—Checksum of the LSP packet
LSP Holdtime—Number of seconds that the LSP remains valid
ATT—Attach bit; indicates that the router is a level 2 router and can reach other areas
P—P bit; detects whether intermediate system is capable of area partition repair
OL—Overload bit; determines whether intermediate system is congested
Area Address—Area addresses that can be reached from the router
NLPID—ISO network layer protocol identifier
IP Address—IP address of the interface
Hostname—Hostname of the router
Router ID—ID configured on the router
Metric —Metric that indicates either of the following costs:
Cost of adjacency between the originating router and the advertised neighbor
Cost between the advertising router and the advertised destination
IPv4 Interface Address—Address of the interface
IPv4 Neighbor Address—Address of a neighbor
Maximum link bandwidth—Bandwidth capacity of the link in bits per second
Reservable link bandwidth—Amount of bandwidth reservable on the link (whether
reserved or not)
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
