Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 332

Software for e series broadband services routers ip, ipv6, and igp configuration guide
Table of Contents

Advertisement

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
308
LDP is configured through LDP autoconfig—Indicates whether LDP is configured on
the interface by means of autoconfiguration; supported only for OSPFv2
LDP-IGP Synchronization—Status of synchronization, Achieved or Pending; supported
only for OSPFv2
Example 1
host1#show ip ospf interface
FastEthernet0 is up, OSPF line protocol is up
OSPF interface configuration:
Internet Address 192.168.1.250, Area 0.0.0.0
Network type BROADCAST, No authentication
Cost: 1
Transmit Delay is 1 sec, Interface State DROTHER, Priority 1
Designated Router (Interface address) 192.168.1.107
Backup Designated Router (Interface address) 192.168.1.214
Timer intervals configured, Hello 10, Dead 40, Wait 120, Retransmit 5
Neighbor Count is 2, Adjacent neighbor count is 2
Adjacent with neighbor 192.168.1.107 (Designated Router)
Adjacent with neighbor 192.168.254.7 (Backup Designated Router)
LDP is configured through LDP autoconfig
LDP-IGP Synchronization: Achieved
Example 2
host1#show ipv6 ospf interface
ATM4/0.12 is up, OSPFv3 line protocol is up
Area 0.0.0.0, Intf ID: 0x320004, Instance ID: 0
Link Local Address: fe80::90:1a00:100:80
Interface is active
Network type POINT-TO-POINT
Interface State POINT-TO-POINT
Cost: 1, Priority 1
No designated router on this network
No backup designated router on this network
Timer intervals configured:
Hello 10, Dead 40, Wait 40
Transmit Delay is 1 sec(s)
Retransmit interval is 5 secs
Neighbor Count is 1
FULL Adjacent neighbor count is 1
Adjacent with neighbor 11.0.0.2
FastEthernet0/0 is up, OSPFv3 line protocol is up
OSPF interface configuration:
Interface ID 0.0.1.1
IPv6 link-local address FE80::3/128
IPv6 prefix address 3000::1/64, Area 0.0.0.0
Network type BROADCAST
Cost: 1
Transmit Delay is 1 sec, Interface State BACKUPDR, Priority 1
Designated Router's router ID 1.1.1.1
Backup Designated Router's router ID 2.2.2.2
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 3.3.3.3 (Designated Router)
See show ip ospf interface
See show ipv6 ospf interface
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents