Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 422

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
show clns protocol
398
Neighbor Restarting—Whether the ES or IS is currently restarting: yes or no
BFD session—State of any BFD session for this neighbor
Example 1—For IS-IS IP configuration
host1#show clns neighbors detail
System Id SNPA
1111.1111.1111
Area Address(es): 11.1111.1111.1111.1111.1111.1111
Ip Address(es): 172.100.11.1
Graceful Restart Capable: yes
Neighbor Restarting: yes
BFD session is not-up
Example 2—For IS-IS IPv6 configuration
host1:2#show clns neighbors detail
System Id SNPA
host1:1 0090.1A41.081A
Area Address(es): 49.0001
Ip Address(es):
Graceful Restart Capable: no
Neighbor Restarting: no
host1:3 0090.1A41.081C
Area Address(es): 49.0001
Ip Address(es):
Graceful Restart Capable: no
Neighbor Restarting: no
See show clns neighbors
Use to display protocol-specific information about a routing process.
Field descriptions
IS-IS Router—IS-IS router name
System ID—Six-byte value of router
IS-Type—Routing level (level 1, level 2, or both) that is enabled on the router
Manual area addresses—Configured area addresses
Routing for area address(es)—Identified for level 1 routing processes. For level 2
routing processes, lists the domain address.
Interfaces supported by IS-IS—Interfaces and type
Distance—Configured distance value
Redistributing—Protocols being redistributed into IS-IS
Example
Interface State Holdtime(rem)
A5/0.1 up 30(29)
Interface State
F1/1 up
4.4.4.1
F1/1 up
4.4.4.3
Copyright © 2010, Juniper Networks, Inc.
Type Proto
L1L2 IS-IS
Holdtime(rem) Type Proto
30(25) L1 IS-IS
30(27) L1 IS-IS