Table of Contents
Advertisement
show clns interface
Copyright © 2010, Juniper Networks, Inc.
host1#show clns is-neighbors detail
System Id
Interface
0000.0000.7500 atm2/0.111 up
Area Address(es): 47.0005.80FF.F800.0000.0001.0001
Ip Address(es):
See show clns
Use to display CLNS-specific information about each interface.
Field descriptions
interface—Status of interface
line protocol—Status of the line protocol, up or down
Checksums—Status of checksum, enabled or disabled
MTU—Maximum transmission size for a packet on this interface
Encapsulation—Encapsulation used by CLNP packets on this interface
Next ESH/ISH—When the next ES hello or IS hello is sent on this interface
Routing Protocol—One or more areas that this interface is in. In most cases, an
interface is in only one area.
Circuit type—Whether the interface has been configured for local routing (level-1),
area routing (level-2), or local and area routing (level-1-2)
Interface number—Number of the interface
local circuit ID—Local circuit ID of the interface
Authentication Level-1—If area authentication is enabled, lists key-id, type of
authentication, start and stop accept times, and start and stop generate times for
the key. An asterisk after the type indicates the key is active.
Authentication Level-2—If domain authentication is enabled, lists key-id, type of
authentication, start and stop accept times, and start and stop generate times for
the key. An asterisk after the type indicates the key is active.
Level 1 and level 2 metrics—Metric value for each level
DIS priority—DIS priority value assigned to the IS-IS router at each level
Priority—Priority value assigned to the IS-IS router at each level
Circuit ID—Circuit ID of the IS-IS router at each level
Number of active level 1 and level 2 adjacencies—Number of adjacencies active at
each level
Designated IS—Name of the designated IS-IS router at each level
State Type Priority
L1L2 127
172.30.245.33
Chapter 6: Configuring IS-IS
Circuit Id
0000.0000.0000.00
395
Advertisement
Table of Contents
