Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 320

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
296
0 normal, 0 stub, 0 NSSA.
Example 2
host1#show ip ospf
Routing Process OSPF 4 with Router ID, 10.0.0.1, Domain ID 0.0.0
OSPF administrative state is enabled
OSPF operational state is enabled
Incremental External SPF is ON
Graceful Restart Capability is OFF
Graceful Restart Helper Capability is OFF
Graceful Restart Help Not Aborted On Topology Change
Ospf set trap field disabled
OSPF Statistics:
Rcvd: 0 total, 0 pkts dropped, 0 checksum errors
0 hello, 0 database desc, 0 link state req
0 link state updates, 0 link state acks
Sent: 1 total, 0 pkts dropped
1 hello, 0 database desc, 0 link state req
0 link state updates, 0 link state acks
LSA discard count: 0
Supports only single TOS(TOS0) routes
SPF schedule delay 0 secs, Hold time between two SPFs 3 secs
Maximum path splits 4
Area BACKBONE(0.0.0.0)
SPF algorithm executed 5 times
ABDR count 0
ASBDR count 0
LSA Count 1
Number of interfaces in this area is 1
Area ranges are:
Area 0.0.0.1
Area is a stub area
Type-3 summary is filtered
SPF algorithm executed 5 times
ABDR count 0
ASBDR count 0
LSA Count 0
Number of interfaces in this area is 0
Area ranges are:
Area 0.0.0.2
Area is nssa
Type-3 summary is filtered
SPF algorithm executed 4 times
ABDR count 0
ASBDR count 0
LSA Count 0
Number of interfaces in this area is 0
Area ranges are:
Area 0.0.0.5
Area is nssa
SPF algorithm executed 3 times
ABDR count 0
ASBDR count 0
LSA Count 0
Number of interfaces in this area is 0
Area ranges are:
Number of active areas in this router is 4
1 normal, 1 stub, 2 NSSA.
Copyright © 2010, Juniper Networks, Inc.