Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 174

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
show ipv6
show ipv6 address
show ipv6 interface
150
To Display
IPv6 addresses
IPv6 forwarding table
IPv6 Interfaces
IPv6 neighbors
IPv6 profile information
Active IPv6 protocol information
IPv6 route redistribution configuration
IPv6 routes
IPv6 router advertisements received
IPv6 static routes
IPv6 statistics/traffic
IPv6 UDP information
IPv6 license string
IPv6 TCP information
You can use the output filtering feature of the show command to include or exclude lines
of output based on a text string that you specify. See JunosE System Basics Configuration
Guide, for details.
Use to display general IPv6 information.
Example
host1#show ipv6
Ipv6 Unicast Routing: Enabled
Default hop limit: not specified
Number of interfaces: 2
Default interface source address/mask: fe80::90:1a00:210:fd0/128
See show ipv6
Command
show ipv6 address
show ipv6 forwarding table slot
show ipv6 interface
show ipv6 neighbors
show ipv6 profile
show ipv6 protocols
show ipv6 redistribute
show ipv6 route
show ipv6 routers
show ipv6 static
show ipv6 traffic
show ipv6 udp statistics
show license ipv6
show tcp statistics
show ipv6 tcp statistics
Copyright © 2010, Juniper Networks, Inc.