Table of Contents
Advertisement
debug ip ospf
debug ipv6 ospf
ospf log-adjacency-changes
undebug ip ospf
undebug ipv6 ospf
Copyright © 2010, Juniper Networks, Inc.
Adjacencies
Designated router
General events
Link-state advertisements
Neighbors
Packets received
Packets sent
Route events
SPF events
Use to display information about selected OSPF events. This command has many
keywords so you can specify a variety of OSPF events.
You can set the level of severity for the events you want displayed: 0–7.
You can set the verbosity of the messages you want displayed: low, medium, high.
Example 1
host1#debug ip ospf adj
Example 2
host1#debug ipv6 ospf lsa
Use the no version to cancel the display of any information about the designated
variable.
See debug ip ospf
See debug ipv6 ospf
Use to enable the logging of changes in the state of an OSPF neighbor.
Example
host1(config-router)#ospf log-adjacency-changes
Use the no version to disable the logging of changes in the state of an OSPF neighbor.
See ospf log-adjacency-changes
Use to cancel the display of information about a selected event.
The same OSPF variables can be designated as in the debug ip ospf or debug ipv6
ospf commands.
Chapter 5: Configuring OSPF
293
Advertisement
Table of Contents
