Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 323

Software for e series broadband services routers ip, ipv6, and igp configuration guide
Table of Contents

Advertisement

Chapter 5: Configuring OSPF
Area—Area for which data is displayed
Router—Number of router LSAs
Network—Number of network LSAs
Intra-Prefix—Number of intra-prefix LSAs
Inter-Prefix—Number of inter-prefix LSAs
Inter-Router—Number of inter-outer LSAs
Link LSAs—Number of link LSAs
Grace LSAs—Number of graceful restart LSAs
External LSAs—Number of external LSAs
MaxAge—Number of LSAs that have reached the maximum age
Area—Area for this LSA
LS age—LSA age
Options—Optional capabilities supported by this router
LS Type—LSA type
Link State ID—Link-state ID of the link local LSA
Length—Length of the LSA (in bytes)
Bit set—Bit set used by this LSA type
Link connected to—Type of network to which the link connects
Neighboring router's Router ID—Router ID of the neighboring router
Neighboring router's Interface ID—Interface ID of the neighboring router
Local Interface ID—Local interface ID
Metric—Cost of this interface
Attached Router—Addresses of any attached routers
Router Priority—Priority value configured for the router
Link Local Address—Originating router's link-local interface address on the link
Prefixes—Prefixes associated with this LSA
Number of Prefixes—Number of prefixes associated with this LSA
Referenced LSA Type—Router LSA or network LSA with which the IPv6 address
prefixes should be associated
Copyright © 2010, Juniper Networks, Inc.
299

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents