Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 252

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
228
Numbered status—Status of the numbered interface from which this interface
obtains its configuration
Send version—Version of RIP used for sending updates
Receive version—Version of RIP accepted in received updates
Authentication mode—Password or MD5 authentication, or none
Default metric—Metric value applied to the RIP interface. The default
is 1.
BFD minimum receive interval(msec)—Configured minimum interval requested
between BFD control packets sent by the remote RIP peer; used with RIP peers to
negotiate a detection interval for BFD session failure. The default is 300
milliseconds.
BFD minimum transmit interval(msec)—Configured minimum interval between
BFD control packets sent by the local RIP peer; used with RIP peers to negotiate
a detection interval for BFD session failure. The default is 300 milliseconds.
BFD multiplier—Multiplied by the negotiated BFD minimum receive interval to
determine the interval between packets permitted before the BFD session is
declared down. Also, the number of BFD control packets that the RIP local peer
can miss before the BFD session is declared down. The default is 3.
Passive Interface—Whether or not the interface is passive, thereby restricting the
interface to unicast RIP messages
Passive Interface—Whether or not the interface is passive, thereby restricting the
interface to unicast RIP messages
Access-list applied to outgoing route—Name of the access list applied to outgoing
routes
Access-list applied to incoming route—Name of the access list applied to incoming
routes
Route-map applied to outgoing route—Name of the route map applied to outgoing
routes
Example 1
host1#show ip rip
Routing Information Protocol
Router Administrative State = enable
System version RIP2: send = 2, receive = 2
No filter is applied to outgoing route update for all interfaces
No filter is applied to incoming route update for all interfaces
No global route map
No table map
Default metric = 1
Distance = 120
Number of route changes = 3
Number of route queries = 0
Copyright © 2010, Juniper Networks, Inc.