Configuring Additional Parameters; Table 11: Additional Configuration Tasks - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual

Configuring Additional Parameters

access-list
route-map
Copyright © 2010, Juniper Networks, Inc.
host1(config)#ip ospf bfd-liveness-detection minimum-interval 800
Example 2 (OSPFv3)
host1(config)#ipv6 ospf bfd-liveness-detection minimum-interval 800
Use the no version to disable BFD on the OSPF interface.
See ip ospf bfd-liveness-detection
See ipv6 ospf bfd-liveness-detection
The commands presented in this section include both OSPF-specific commands and
routing protocol–independent commands that are not limited to OSPF. You can use
these commands to perform the tasks listed in Table 11 on page 271.

Table 11: Additional Configuration Tasks

Filter and apply policy to routes.
Set a baseline for statistics.
Clear statistics for access lists, counters,
redistributed routes, or processes.
Set the redistribution routes.
Set the distance for OSPF routes.
Administratively disable OSPF.
Use the access-list command to create a standard or extended access list.
Use the route-map command to create a route map.
For detailed information about configuring access lists and route maps, see JunosE IP
Services Configuration Guide.
Example
Configure three static routes.
1.
host1(config)#ip route 20.20.20.0 255.255.255.0 192.168.1.0
host1(config)#ip route 20.20.21.0 255.255.255.0 192.168.1.0
host1(config)#ip route 20.21.0.0 255.255.255.0 192.168.1.0
Configure an access list with filters on routes 20.20.20.0/24 and 20.20.21.0/24.
2.
host1(config)#access-list boston permit 20.20.0.0 0.0.255.255
Chapter 5: Configuring OSPF
Set the maximum paths.
Enable automatic cost calculation.
Enable logs for OSPF neighbor changes.
Set SPF hold time.
Set a default metric.
Enable use of the configured bandwidth
for OSPF cost calculation.
271