Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
show ipv6 udp statistics
show license ipv6
show tcp statistics
178
ICMPv6 statistics:
Rcvd:
0 total, 0 errors
0 destination unreach, 0 admin unreach, 0 parameter problem
0 time exceeded, 0 pkt too big, 0 redirects
0 echo requests, 0 echo replies
0 rtr solicits, 0 rtr advertisements
0 neighbor solicits, 0 neighbor advertisements
Group membership: 0 queries, 0 responses, 0 reductions
Sent:
3 total, 0 errors
0 destination unreach, 0 admin unreach, 0 parameter problem
0 time exceeded, 0 pkt too big, 0 redirects
0 echo requests, 0 echo replies
0 rtr solicits, 0 rtr advertisements
2 neighbor solicits, 1 neighbor advertisements
Group membership: 0 queries, 0 responses, 0 reductions
UDP Statistics:
Rcvd: 0 total, 0 checksum errors, 0 no port
Sent: 0 total, 0 errors
See show ipv6 traffic
Use to display IPv6 UDP statistics.
Example
host1#show ipv6 udp statistics
UDP Statistics:
Rcvd: 0 total, 0 checksum errors, 0 no port
Sent: 0 total, 0 errors
See show ipv6 udp statistics
Use to display the IPv6 license key configured on the router.
Example
host1#show license ipv6
Ipv6 license is ipv6_license
See show license
Use to display all TCP statistics (both IPv4 and IPv6).
Baselining is supported for this command.
Use the ip keyword to display only IPv4 statistics.
Use the ipv6 keyword to display only IPv6 statistics.
Use the brief keyword to display summary information or the detailed keyword to
display extensive information.
Use the diagnostic keyword to display diagnostic information collected on the TCP
statistics in addition to the detailed information. This command shows information
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 and is the answer not in the manual?
Questions and answers