Monitoring Is-Is; System Event Logs; Monitoring Is-Is Parameters - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual

Monitoring IS-IS

System Event Logs

Monitoring IS-IS Parameters

Copyright © 2010, Juniper Networks, Inc.
host1(config-router)#protocol shutdown
Use the no version to reenable the IS-IS protocol.
See protocol shutdown
The CLI has commands available for monitoring IS-IS parameters and CLNS parameters.
To troubleshoot and monitor IP, use the following system event logs:
isisAdjChange—IS-IS adjacency up or down events
isisAdjPackets—IS-IS adjacency hello packets
isisBfdEvents—IS-IS interactions with BFD
isisChecksumErr—IS-IS checksum errors
isisGeneral—IS-IS system notifications
isisHelloGeneral—IS-IS system notifications
isisHelloPackets—IS-IS hello packets
isisipv6Log—IS-IS IPv6 notifications
isisLdpEvents—IS-IS interactions with LDP
isisLocalUpdate—IS-IS local LSP packets
isisMplsTeAdvertisements—IS-IS MPLS traffic engineering advertisements
isisMplsTeEvents—IS-IS MPLS traffic engineering
isisNsfEvents—IS-IS nonstop forwarding events during warm starts
isisProtocolErr—IS-IS protocol errors
isisSnpPackets—IS-IS complete sequence numbers PDU (CSNP) and partial sequence
numbers PDU (PSNP) packets
isisSpfEvents—IS-IS Shortest Path First (SPF)
isisSpfStatistics—IS-IS SPF timing and statistic data
isisSpfTriggers—IS-IS SPF triggering
isisUpdate Packets—IS-IS LSP packets sent or received
For more information about using event logs, see the JunosE System Event Logging
Reference Guide.
You can monitor the IS-IS link-state database and IS-IS debug information. Use the
commands in this section to:
Chapter 6: Configuring IS-IS
377