Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 310

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
authentication-none
cost
dead-interval
hello-interval
286
There is no no version.
See authentication message-digest
Use to specify that no authentication is to be used on the OSPF remote neighbor
interface.
Example
host1(config-router-rn)#authentication-none
There is no no version.
See authentication-none
Use to specify a cost metric for the OSPF remote-neighbor interface; the metric is used
in the calculation of the SPF routing table.
The default value is 10 if there is no route to the remote neighbor; otherwise, the default
is calculated based on the bandwidth of the physical interface used to reach the remote
neighbor and the OSPF autocost reference bandwidth.
Example
host1(config-router-rn)#cost 235
Use the no version to restore the default value.
See cost
Use to set the time period, in seconds, that the OSPF router waits without receiving
hello packets from a remote neighbor before declaring the neighbor to be down.
Example
host1(config-router-rn)#dead-interval 180
Use the no version to restore the default value, 40 seconds.
See dead-interval
Use to set the time interval between hello packets that the router sends on the OSPF
remote-neighbor interface.
Specify a value in the range 1–65535 seconds; the default value is 40 seconds.
Example
host1(config-router-rn)#hello-interval 15
Use the no version to restore the default value, 40 seconds.
See hello-interval
Copyright © 2010, Juniper Networks, Inc.