Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
396
Next IS-IS LAN level Hello—Amount of time (in seconds) before the next IS-IS LAN
level 1 or level 2 hello message occurs
BFD—State of BFD for IS-IS, enabled or disabled
Mesh Group—Status of the mesh group, Active or Inactive
LDP-IGP Synchronization—Status of synchronization, Achieved or Pending; supported
only for OSPFv2
When you specify the brief keyword, the output includes the following fields.
interface—Name of the interface
state—State of the interface, up or down
level—Configured interface level, level-1, level-2, or level-1-2
DIS(L-1)—Level-1 designated intermediate system (DIS) in a multiaccess network
DIS(L-2)—Level-2 designated intermediate system (DIS) in a multiaccess network
l1/l2 Metric—Metric for the interface
Example 1
host1#show clns interface
FastEthernet4/1 is up, line protocol is up
Checksums Enabled, MTU 1500, Encapsulation SNAP
Next ESH/ISH is 5 seconds
Routing Protocol: IS-IS
Circuit Type: level-1-2
Interface number 0x10, local circuit ID 0x1
Level-1 Metric: 10, DIS Priority: 0, Priority: 64,
Circuit ID: 0000.0000.0000.01
Designated IS: Getafix:v2.01 (us)
Number of active level-1 adjacencies: 0
Level-2 Metric: 10, DIS Priority: 0, Priority: 64,
Circuit ID: 0000.0000.0000.01
Designated IS: Getafix:v1.01 (Not Us)
Number of active level-2 adjacencies: 1
Next IS-IS LAN Level-1 Hello in 7 seconds
Next IS-IS LAN Level-2 Hello in 6 seconds
BFD disabled
Mesh Group Inactive
LDP is configured through LDP autoconfig
LDP-IGP Synchronization: Achieved
Example 2
host1#show clns interface brief
Clns Intf brief Table
--------------------
interface
state
-------------
-----
level
DIS(L-1)
---------
-------------
Copyright © 2010, Juniper Networks, Inc.
l1/l2
DIS(L-2)
Metric
--------------
------
Advertisement
Table of Contents
