Table of Contents
Advertisement
clear ip isis redistribution
clear isis ipv6 redistribution
disable-dynamic-redistribute
Copyright © 2010, Juniper Networks, Inc.
host1(config)#router isis testnet
host1(config-router)#redistribute static ip route-map 1
Use the show isis database command to verify the effect of the redistribution (that
5.
two static routes matching the route map are redistributed as level 2 internal routes):
host1#show isis database detail l2
IS-IS Level-2 Link State Database
LSPID LSP Seq Num
0000.0000.6666.00-00
Area Address: 47.0005.80FF.F800.0000.0001.0001
NLPID:
0xcc
IP Address:
192.168.1.105
Metric: 10 IS 0000.0000.6666.01
Metric: 10 IS 0000.0000.3333.00
Metric: 10 IS 0000.0000.7777.00
Metric: 30 IP 10.20.21.0 255.255.255.0
Metric: 30 IP 10.20.20.0 255.255.255.0
Use the no version of the access-list command to remove the access list or the specified
entry in the access list.
Use the no version of the route-map command to remove an entry.
See access-list
See route-map
Use to clear all the routes that have been previously redistributed into IS-IS and to
redistribute them using the current policy configured. Use the IP version to redistribute
IP routes. Use the IPv6 version to redistribute IPv6 routes.
Use when you have made changes to route maps or access lists that affect how routes
are redistributed to IS-IS.
Example
host1#clear ip isis redistribution
There is no no version.
See clear ip isis redistribution
See clear isis ipv6 redistribution
Use to halt the dynamic redistribution of routes that are initiated by changes to a route
map.
Dynamic redistribution is enabled by default.
Example
host1(config-router)#disable-dynamic-redistribute
LSP Checksum
LSP Holdtime
0x000002B7
0x3E1F 1198 0/0/0
Chapter 6: Configuring IS-IS
ATT/P/OL
351
Advertisement
Table of Contents
