Assigning A Profile - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
ipv6 unnumbered
ipv6 virtual-router

Assigning a Profile

profile
132
Use to set up an unnumbered interface.
An unnumbered interface does not have an IPv6 address assigned to it. Unnumbered
interfaces are often used in point-to-point connections where an IPv6 address is not
required.
This command enables IPv6 processing on an interface without your having to assign
an explicit IPv6 address to the interface.
You supply an interface location that is the type and number of another interface on
which the router has an assigned IPv6 address. This interface cannot be another
unnumbered interface.
Example
host1(config-if)#ipv6 unnumbered loopback 0
Use the no version to disable IPv6 processing on an interface.
See ipv6 unnumbered
Use to assign a virtual router to a profile.
You can configure a virtual router using RADIUS instead of adding one to the profile
by using the ipv6 virtual-router command.
Example
host1(config-profile)#ipv6 virtual-router VR6
Use the no version to remove the virtual router assignment.
See ipv6 virtual-router
To assign a profile to an interface, use the profile command from Interface mode.
Use to assign a profile to a PPP interface. The profile configuration is used to
dynamically create an upper IP interface.
Example
host1(config-if)#interface atm 3/1.50
host1(config-if)#encapsulation ppp
host1(config-if)#profile boston
Use the no version to remove the assignment from the interface.
See profile
Copyright © 2010, Juniper Networks, Inc.