Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Interface—Interface type on which RIP protocol is running
Redistributing—Protocol to which RIP is redistributing routes
Routing for Networks—Network for which RIP is currently injecting routes
Example
host1#show ip protocols
Routing Protocol is
Redistributing: ospf
Default local preference is 100
IGP synchronization is enabled
Always compare MED is disabled
Router flap damping is disabled
Administrative Distance: external 20 internal 200 local 200
Neighbor(s):
Address 1.1.1.1
Outgoing update distribute list is 2
Outgoing update prefix list is efg
Incoming update prefix tree is abc
Incoming update filter list is 1
Routing for Networks:
192.168.1.0/24
Routing Protocol is
System Id: 0000.0000.0011.00
Distance: 115
Address Summarization:
None
Routing for Networks:
fastEthernet0/0
Routing Protocol is
Distance is 110
Redistributing: isis
Address Summarization:
None
Routing for Networks:
192.168.1.0/255.255.255.0 area 0.0.0.0
Routing Protocol is
Router Administrative State: enable
System version RIP1: send = 1, receive = 1 or 2
Update interval: 30 seconds
Invalid after: 180
hold down time: 120 seconds
flushed interval: 300 seconds
Filter applied to outgoing route update is not set
Filter applied to incoming route update is not set
No global route map
Distance is 120
Interface
fastEthernet0/0
Redistributing: ospf
Routing for Networks:
192.168.1.0/255.255.255.0
See show ip protocols
bgp 100"
isis isisOne"
IS-Type: level-1-2
ospf 1"
with Router ID 192.168.1.151
rip"
seconds
Tx
Rx
Auth
1
1,2
none
Chapter 1: Configuring IP
95
Advertisement
Table of Contents
