Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
baseline ip rip
show ip rip
226
Use to set a statistics baseline for RIP interfaces.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Use the optional delta keyword with the show ip rip statistics command to specify
that baselined statistics are to be shown.
Example
host1#baseline ip rip
There is no no version.
See baseline ip rip
Use to display RIP information.
Specify vrf vrfName to limit the display to a specific VRF.
Use the ifconfig keyword to display address and interface configuration information
instead of the default operational data.
Field descriptions
Router Information Protocol Fields
Router Administrative State—Displays the RIP state. Enable means the router is
allowed to send and receive updates. Disable means that RIP might be configured
but it is not allowed to run yet.
System version RIP1—RIP versions allowed for sending and receiving RIP updates.
The router version is currently set to RIP1, which sends RIPv1 but will receive RIPv1
or RIPv2. If it is set to RIP2, it will send and receive RIPv2 only. The default is
configured for RIP1.
Incoming filters—Access list applied to incoming route updates
Outgoing filters—Access list applied to outgoing route updates
Global route map—Route map that specifies all RIP interfaces on the router
Default metric—Value for redistributed routes. The default is 1. This global value
is superseded by metrics applied to a RIP interface.
Distance—Value added to RIP routes added to the IP routing table. The default is
120.
Number of route changes—Number of times the router has been told to route
changes by its peers
Number of route queries—Number of times the router has received route requests
from other routers
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
