Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 89

frequency
operations-per-hop
owner
request-data-size
tag
Copyright © 2010, Juniper Networks, Inc.
Table 7: Probe Characteristics (continued)
Characteristic Description
timeout Probe timeout (in milliseconds)
tos A value for the TOS byte
Use to set the rate (in seconds) that the RTR probe uses to start a response time
operation.
Example
host1(config-rtr)#frequency 90
Use the no version to return to the default value, 60 seconds.
See frequency
Use to set the number of RTR probe operations sent to a given hop.
You can apply this option only to a pathEcho type.
Example
host1(config-rtr)#operations-per-hop 5
Use the no version to return to the default, 3.
See operations-per-hop
Use to identify the owner of the probe.
If the SNMP agent is the owner of the probe, the owner's name can begin with agent.
Example
host1(config-rtr)#owner 192.10.27.6 rtc.boston.com 555.1212
Use the no version to return to the default, no owner.
See owner
Use to set the protocol data size, in bytes, in the request packet.
Example
host1(config-rtr)#request-data-size 20
Use the no version to return to the default value, 1 byte.
See request-data-size
Chapter 1: Configuring IP
65