Configuring The Probe Type - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual

Configuring the Probe Type

rtr
type
Copyright © 2010, Juniper Networks, Inc.
frequency
hops-of-statistics-kept (path echo)
max-response-failure (path echo)
operations-per-hop (path echo)
owner
receive-interface
request-data-size
samples-of-history-kept
tag
timeout (echo)
tos
NOTE: You cannot set any of these characteristics until you have set
the probe type. The default values of these characteristics depend on
the type of the entry.
(Optional) Set reaction conditions.
3.
Schedule the probe.
4.
(Optional) Capture statistics and collect error information.
5.
(Optional) Collect history.
6.
To begin configuring RTR, enter RTR Configuration mode and configure the probe
type—either an echo probe or a path echo probe.
Use to configure an RTR probe and to enter RTR Configuration mode.
Example
host1(config)#rtr 1
Use the no version to delete all configuration information for an RTR probe.
See rtr
Use to set an echo or path echo probe:
echo—Limited to end-to-end RTR operations; corresponds to SNMP ping
Chapter 1: Configuring IP
63