Table of Contents
Advertisement
clear isis database
Copyright © 2010, Juniper Networks, Inc.
IS-IS: Adjacencies Changes: 1
IS-IS: Adjacencies Rejected: 0
IS-IS: Bad LSPs: 0
IS-IS: Level-1 Designated IS Changes: 0
IS-IS: Level-2 Designated IS Changes: 0
IS-IS: Invalid 9542s: 0
host1#baseline clns atm 2/1.3
host1#show clns traffic detail delta
IS-IS: Baseline last set 0 days, 0 hours, 2 minutes, 27 seconds
IS-IS: Corrupted LSPs: 0
IS-IS: L1 LSP Database Overloads: 0
IS-IS: L2 LSP Database Overloads: 0
IS-IS: Area Addresses Dropped: 0
IS-IS: Attempts to Exceed Max Sequence: 0
IS-IS: Sequence Numbers Skipped: 6
IS-IS: Own LSPs Purged: 1
IS-IS: System ID Length Mismatches: 0
IS-IS: Maximum Area Mismatches: 0
Interface: atm2/1.3
IS-IS: Baseline last set 0 days, 0 hours, 0 minutes, 8 seconds
IS-IS: Protocol PDUs (in/out): 2/1
IS-IS: Init Failures: 0
IS-IS: Adjacencies Changes: 0
IS-IS: Adjacencies Rejected: 0
IS-IS: Bad LSPs: 0
IS-IS: Level-1 Designated IS Changes: 0
IS-IS: Level-2 Designated IS Changes: 0
IS-IS: Invalid 9542s: 0
There is no no version.
See baseline clns
Use to delete all entries from the IS-IS link-state database, or only the entries associated
with the specified neighbor.
Field descriptions
LSPID—LSP identifier
LSP Seq Num—Sequence number for the LSP. Enables other routers to determine
if they have received the latest information from source.
LSP Checksum—Checksum of the LSP packet
LSP Holdtime—Number of seconds that the LSP remains valid
ATT—Attach bit; indicates that the router is a level 2 router and can reach other areas
P—P bit; detects whether intermediate system is capable of area partition repair
OL—Overload bit; determines whether intermediate system is congested
Example
host1#show isis database
IS-IS Level-1 Link State Database
Chapter 6: Configuring IS-IS
391
Advertisement
Table of Contents
