Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
show ipv6 profile
show ipv6 protocols
170
By state: 5 reachable, 0 incomplete, 2 stale, 0 probe, 0 delay, 0 init
IPv6 address conflicts: 0 during DAD resolution, 0 after DAD resolution
See show ipv6 neighbors
Use to display information about a specific IPv6 profile.
Field descriptions
IPv6 profile—Profile name
Unnumbered interface—Specifier for the unnumbered interface or none if the interface
is numbered
Router—Router name
Access Route Addition—Enabled or disabled
Source-Address Validation—Enabled or disabled
Administrative MTU—MTU size
Example
host1#show ipv6 profile foo
IPv6 profile : foo
Unnumbered interface on : loopback 0
Router
Access Route Addition
Source-Address Validation
Administrative MTU
See show ipv6 profile
Use to display configured protocols.
Field descriptions
Local router ID—Router ID of the local router
Local AS—AS number of local router
Administrative state—Administrative state of the protocol
Operational state—Operational state of the protocol
Shutdown in overload state—Status of shutdown in an overload state
Default local preference—Default value for local preference
IGP synchronization—Indicates whether synchronization is enabled or disabled
Default originate—Indicates whether network 0.0.0.0 is redistributed into BGP
Auto summary—Status of autosummary
: r1
: Enabled
: Disabled
: 0
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
