Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
312
Use to display all interfaces that are associated with OSPF remote neighbors.
Field descriptions
OSPF remote-neighbor—Remote neighbor address for this interface
Update-source—Update source for this interface
Remote-neighbor reachable—Reachable status of the remote neighbor, yes or no
Area—Area of this interface
Network type—Network type for this interface
Cost—Cost value for this interface
Transmit Delay—Transmit delay for this interface, in seconds
Interface State—Interface state
Priority—Priority value for this interface
Designated router—Designated router on this network, if any
Backup designated router—Backup designated router on this network, if any
Hello—Hello timer value, in seconds
Dead—Dead interval timer value, in seconds
Wait—Wait interval timer value, in seconds
Retransmit—Retransmit interval timer value, in seconds
Neighbor Count—Number of neighbors to this interface
Adjacent neighbor count—Number of adjacent neighbors to this interface
Adjacent with neighbor—Address of the neighbor adjacent to this interface
Example
host1#show ip ospf remote-neighbor interface
OSPF remote-neighbor 221.221.221.221 interface configuration:
Update-source loopback0
Remote-neighbor reachable: yes
Area 0.0.0.0
Network type POINT-TO-POINT, No authentication
Cost: 1
Transmit Delay is 1 sec, Interface State POINT-TO-POINT, Priority 1
No designated router on this network
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 221.221.221.221
See show ip ospf remote-neighbor interface
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
