Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 127

show ip static
Copyright © 2010, Juniper Networks, Inc.
opts = 13 SO_DEBUG SO_REUSEADDR SO_KEEPALIVE
so_state = 177 SS_NOFDREF SS_CANTSENDMORE SS_CANTRCVMORE SS_PRIV
18 0.0.0.0:23 --> 0.0.0.0:0
type: 1 (SOCK_STREAM)
opts = 7 SO_DEBUG SO_ACCEPTCONN SO_REUSEADDR
so_state = 128 SS_PRIV
Example 2—Additional fields displayed by detailed keyword
host1#show ip socket statistics detailed
18 0.0.0.0:23 --> 0.0.0.0:0
type: 1 (SOCK_STREAM)
opts = 7 SO_DEBUG SO_ACCEPTCONN SO_REUSEADDR
so_state = 128 SS_PRIV
pending xmit byte count = 0
Keep alive idle time = 14400
Additional state flags:
so_Bound
so_ListenOk
ss_CalledRsSocreate
so_SendtoCalls = 0
so_SendMsgCalls = 0
so_SendCalls = 0
so_SockWriteCalls = 0
so_SendErrors = 0
so_SentBytes = 0
so_BsdCloseNotClosed = 0
so_RecvBytes = 0
so_RecvErrors = 0
so_RecvFroms = 0
so_Recvs = 0
so_RecvMsgs = 0
so_Reads = 0
Socket Event Log (most recent at bottom)
rssocket
sobind - 0
bind - 0
solisten - 0
listen - 0
See show ip socket statistics
Use to display the status of static routes in the routing table.
You can specify an IP mask that filters specific routes.
Field descriptions
Prefix—IP address prefix
Length—Prefix length
Next Hop—IP address of the next hop
Met—Number of hops
Dist—Administrative distance of the route; see Table 5 on page 27
Chapter 1: Configuring IP
recv count 0
keep alive poll time = 150
103