Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 281

ipv6 ospf network
ip ospf priority
ipv6 ospf priority
ip ospf retransmit-interval
Copyright © 2010, Juniper Networks, Inc.
Use to specify that the interface disregard the MTU size contained in the data description
packet.
When enabled, the interface accepts data description packets from its neighbor even
if it has a different MTU size (the MTU size must be less than 18000).
Specify an optional process ID in the range 1–65535.
Example
host1(config-if)#ipv6 ospf mtu-ignore
Use the no version to reset the default: that the neighbor MTU size must match the
MTU size of the OSPFv3 interface from which the packet is received.
See ipv6 ospf mtu-ignore
Use to configure the OSPF network type for an interface.
Specify a network type (broadcast or point-to-point) for the interface.
Example
host1(config)#interface fastethernet 0/0
host1(config-if)#ipv6 ospf network broadcast
Use the no version to revert the network type to the default for the interface.
See ipv6 ospf network
Use to configure the router's priority.
Select a priority level in the range 0–255; the default value is 1.
This setting determines the designated router for the particular network.
A router whose priority is set to 0 cannot be a designated router.
Configure priority only for interfaces to multiaccess networks.
For the IPv6 command, you can specify an optional process ID in the range 1–65535.
Example 1
host1(config-if)#ip ospf priority 2
Example 2
host1(config-if)#ipv6 ospf priority 2
Use the no version to restore the default value, 1.
See ip ospf priority
See ipv6 ospf priority
Chapter 5: Configuring OSPF
257