Related Topics
Monitoring the QoS Configuration of IP Interfaces
Display the QoS configuration on a particular IP interface.
Purpose
A dynamic IP interface can have a QoS profile attached by RADIUS. For example, if
configured by RADIUS, the show ip interface command might show the following:
However, if the profile is configured statically, the QoS profile is attached to the ATM
subinterface, and the attachment is displayed by the show atm subinterface
command rather than show ip interface.
To display the QoS configuration for an IP interface:
Action
host1#show ip interface atm 2/0.1
ATM2/0.1 line protocol Atm1483 is up, ip is up
..........................................
Table 50 on page 346 lists the related show ip interface command output fields.
Meaning
Configuring the QoS Shaping Mode for ATM Interfaces on page 174
Configuring a QoS Profile on page 132
Attaching a QoS Profile to an Interface on page 134
Creating Parameter Instances
For more information about other fields displayed with this command, see
JUNOSe Link Layer Configuration Guide
show atm interface
show interfaces atm
Attached QoS profile: Strict-qos
Attached QoS profile: test @ ATM2/0
queue 0: traffic class best-effort, bound to ip ATM2/0.1
Queue length 0 Bytes
Forwarded packets 0, Bytes 0
Dropped committed packets 0, Bytes 0
Dropped conformed packets 0, Bytes 0
Dropped exceeded packets 0, Bytes 0
Dropped by WRED committed packets 0, bytes 0
Dropped by WRED conformed packets 0, bytes 0
Dropped by WRED exceeded packets 0, bytes 0
Average queue length 150576 bytes
queue 1: traffic class tc1, bound to ip ATM2/0.1
Queue length 0 Bytes
Forwarded packets 0, Bytes 0
Dropped committed packets 0, Bytes 0
Dropped conformed packets 0, Bytes 0
Dropped exceeded packets 0, Bytes 0
Dropped by WRED committed packets 0, bytes 0
Dropped by WRED conformed packets 0, bytes 0
Dropped by WRED exceeded packets 0, bytes 0
Average queue length 150576 bytes
Chapter 31: Monitoring QoS on E Series Routers
Monitoring the QoS Configuration of IP Interfaces
345