VRRP Commands
vrrp ip
The vrrp ip interface configuration command defines Virtual Router Redundancy Protocol (VRRP)
for an interface. To delete the definition, use the no form of this command.
Syntax
vrrp virtual-router ip ip-address [ip-address2...ip-address8]
no vrrp virtual-router ip
•
virtual-router—Virtual router number on the interface for which VRRP is being defined.
(Range: 1 - 255)
•
ip-address—Virtual router IP address. Up to 8 IP addresses can be defined in one
command line. One IP address is required.
Default Configuration
No Virtual Router is defined.
Command Mode
Interface configuration (Ethernet, VLAN, port-channel)
User Guidelines
This command cannot be used with a range of ports.
Example
The following example defines VRRP with the IP address 172.16.1.1 and 172.16.2.1 for port g8.
Console(config)# interface ethernet g8
Console(config-if)# vrrp 19 ip 172.16.1.1 172.16.2.1
vrrp up
The vrrp up interface configuration command activates Virtual Router Redundancy Protocol
(VRRP) on an interface. To disable VRRP, use the no form of this command.
Syntax
vrrp virtual-router up
no vrrp virtual-router up
•
virtual-router—Virtual router number on the interface for which VRRP is being activated.
(Range: 1 - 255)
469
VRRP Commands