Show Interfaces Status - Dell PowerConnect 6024F Command Line Interface Reference Manual
Command
line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 6024F:
- User manual (474 pages) ,
- Getting started manual (66 pages) ,
- Getting started manual (154 pages)
Table of Contents
Advertisement
The displayed port configuration information includes the following:
•
Port—The port number.
•
Port Type—The port designated IEEE shorthand identifier. For example 1000Base-T refers to
1000 Mbps baseband signaling inluding both Tx and Rx transmissions.
•
Duplex—Displays the port Duplex status.
•
Speed—Refers to the port speed.
•
Neg—Describes the Auto-negotiation status.
•
Flow Control—Displays the Flow Control status.
•
Back Pressure—Displays the Back Pressure status.
•
MDIX Mode—Displays the Auto-crossover status.
•
Admin State—Displays whether the port is enabled or disabled.
show interfaces status
The show interfaces status user EXEC command displays the status for all configured interfaces.
Syntax
show interfaces status [ethernet interface | port-channel port-channel-number | oob-eth oob-
interface]
•
interface—A valid Ethernet port.
•
port-channel-number—A valid port-channel trunk index.
•
oob-interface—Out-of-Band Ethernet port number.
Default Configuration
This command has no default configuration.
Command Mode
Privilege EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the status for all configured interfaces.
140
Ethernet Configuration Commands
Advertisement
Table of Contents
