Show Ip Igmp Interface - Dell PowerConnect 6024F Command Line Interface Reference Manual
Command
line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 6024F:
- User manual (474 pages) ,
- Getting started manual (66 pages) ,
- Getting started manual (154 pages)
Table of Contents
Advertisement
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the DVMRP upstream prune state.
Console# show ip dvmrp prune
Group
-------------
------------
224.192.78.88
171.68.0.0/16
224.192.78.89
171.68.0.0/16
The following table describes the fields shown in the display:
Field
Group
Source
Expiry time
show ip igmp interface
The show ip igmp interface user EXEC command displays IGMP related information about an
interface.
Syntax
show ip igmp interface [ethernet interface-number | vlan vlan-id | port-channel number]
•
ethernet interface-number—Ethernet port number.
•
vlan vlan-id—VLAN number.
•
port-channel number—Port-channel number.
Default Configuration
This command has no default configuration.
Source
Description
The group address which has been pruned
The address of the source or source network which has been pruned.
The amount of time remaining before this prune expires at the upstream
neighbor. This value should be the minimum of the default prune lifetime and
the remaining prune lifetimes of the local router downstream neighbors, if any.
Expiry
Time
--------
00:02:52
00:08:52
Multicast Routing Commands
229
Advertisement
Table of Contents
