Key-Chain - Dell PowerConnect 6024F Command Line Interface Reference Manual
Command
line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 6024F:
- User manual (474 pages) ,
- Getting started manual (66 pages) ,
- Getting started manual (154 pages)
Table of Contents
Advertisement
•
reject-route—Discard all packets matching this route per RFC-2096, and handle them as
reject-route. These routes are treated as unreachable networks, and an ICMP
unreachable route is returned.
Default Configuration
The metric default distance is 1.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example establishes a static route to 172.16.0.0.
Console (config)# ip route 172.16.0.0 255.255.0.0
key-chain
The key-chain global configuration command defines authentication key group for routing
protocols. To remove the key chain, use the no form of this command.
Syntax
key-chain name-of-chain
no key-chain name-of-chain
•
name-of-chain—Key chain name.
Default Configuration
No key chain exists.
Command Mode
Global Configuration mode
User Guidelines
To use, an authentication key chain with keys must be configured.
The setting is effective only after reset.
RIP may use only up to two parallel paths.
After specifying the key-chain command, the key chain configuration mode is opened.
184
IP Routing Protocol-Independent Commands
131.16.1.1
Advertisement
Table of Contents
