Ip Http Authentication - Dell PowerConnect 6024F Command Line Interface Reference Manual

User Guidelines
There are no user guidelines for this command.
Example
The following example specifies the default authentication method when accessing a higher
privilege level from a remote Telnet or console.
Console (config)# line console
Console (config-line)# enable authentication default

ip http authentication

The ip http authentication global configuration mode command specifies authentication methods
for http. To return to the default, use the no form of this command.
Syntax
ip http authentication method1 [method2...]
no ip http authentication
• method1 [method2...]—Specify at least one from the following table:
Keyword
local
none
tacacs
radius
Default Configuration
The local user database is checked. This has the same effect as the command ip http
authentication local.
Command Mode
Global Configuration mode
User Guidelines
The additional methods of authentication are used only if the previous method returns an
error, not if it fails. To ensure that the authentication succeeds even if all methods return an
error, specify none as the final method in the command line.
NOTE:
Make sure that the given sequence of authentication methods is sensible. For example, a
sequence where Radius follows None is not sensible because None requires no authentication and,
therefore, the process will never require Radius authentication.
Source or destination
Uses the local username database for authentication.
Uses no authentication.
Uses the list of all TACACS+ servers for authentication.
Uses the list of all RADIUS servers for authentication.
61
AAA Commands