Ip Igmp Snooping Leave-Time-Out; Show Ip Igmp Snooping Mrouter - Dell PowerConnect 6024F Command Line Interface Reference Manual

Example
The following example configures the mrouter timeout to 200 seconds.
Console (config)# interface vlan 2
Console (config-if)# ip igmp snooping mrouter-time-out 200

ip igmp snooping leave-time-out

The ip igmp snooping leave-time-out command configures the leave-time-out. If an IGMP report
for a Multicast group is not received within the leave-time-out period after an IGMP leave was
received from a specific port, the current port is deleted from the member list of that Multicast
group. To configure the default leave-time-out, use the no form of this command.
Syntax
ip igmp snooping leave-time-out {time-out | immediate-leave}
no ip igmp snooping leave-time-out
• time-out—leave-time-out in seconds. (Range: 0 - 2147483647)
• immediate-leave—Specifies that the port should be immediately removed from the
members list after receiving IGMP Leave.
Default Configuration
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
The leave timeout should be set greater than the maximum time that a host is allowed to
respond to an IGMP Query.
Use immediate leave only where there is only one host connected to a port.
The following example configures the host leave-time-out to 60 seconds.
Console (config)# interface vlan 2
Console (config-if)# ip igmp snooping leave-time-out 60

show ip igmp snooping mrouter

The show ip igmp snooping mrouter User EXEC command displays information on dynamically
learned Multicast router interfaces.
178
IGMP Snooping Commands