Radius Commands; Rip Commands - Dell PowerConnect 6024F Command Line Interface Reference Manual

class
police
police aggregate
trust
set
service-policy

Radius Commands

Command Group
radius-server host
radius-server key
radius-server retransmit
radius-server source-ip
radius-server timeout
radius-server deadtime
show radius-servers

RIP Commands

Command Group
router rip enable
router rip redistribute ospf
router rip redistribute static
rip
rip passive-interface
rip auto-send
rip version
40
Command Groups
Defines the traffic classification and enters the policy-map class
configuration mode.
Defines a policer for the classified traffic.
Applies an aggregate policer to multiple classes within the same policy
map.
Configures the trust state.
Sets new values in the IP packet.
Applies a policy map to the interface input.
Description
Specifies a RADIUS server host.
Sets the authentication and encryption key for all RADIUS
communications between the router and the RADIUS daemon.
Specifies the number of times the software searches the list of
RADIUS server hosts.
Specifies the source IP address used for communication with RADIUS
servers.
Sets the interval for which a router waits for a server host to reply.
Improves RADIUS response times when servers are unavailable.
Displays the RADIUS server settings.
Description
Enables the RIP on the device.
Advertises routes learned by OSPF in the RIP process.
Advertises routes statically learned in the RIP process.
Creates a Routing Information Protocol (RIP) process on an interface.
Disables the sending of routing updates on an interface.
Automatically detects if RIP information is required to be sent on the
interface.
Specifies a RIP version.
PM
PM
PM
PM
PM
IC
Mode
GC
GC
GC
GC
GC
GC
UE
Mode
GC
GC
GC
IC
IC
IC
IC