Configure Bfd For Vrrp - Dell Force10 Z9000 Configuration Manual

BGP state ESTABLISHED, in this state for 00:05:33
...
Neighbor is using BGP neighbor mode BFD configuration
Peer active in peer-group outbound optimization
...
R2# show ip bgp neighbors 2.2.2.4
BGP neighbor is 2.2.2.4, remote AS 1, external link
Member of peer-group pg1 for session parameters
BGP version 4, remote router ID 12.0.0.4
BGP state ESTABLISHED, in this state for 00:05:33
...
Neighbor is using BGP peer-group mode BFD configuration
Peer active in peer-group outbound optimization
...

Configure BFD for VRRP

When using BFD with VRRP, the VRRP protocol registers with the BFD manager on the route processor module (RPM). BFD
sessions are established with all neighboring interfaces participating in VRRP. If a neighboring interface fails, the BFD agent on the
line card notifies the BFD manager, which in turn notifies the VRRP protocol that a link state change occurred.
Configuring BFD for VRRP is a three-step process:
1. Enable BFD globally. Refer to
2. Establish VRRP BFD sessions with all VRRP-participating neighbors.
3. On the master router, establish a VRRP BFD sessions with the backup routers. Refer to
Neighbors.
Related Configuration Tasks
• Changing VRRP Session
• Disabling BFD for VRRP.
142
Bidirectional Forwarding Detection (BFD)
Enabling BFD Globally.
Parameters.
Establishing Sessions with All VRRP