Configuration And Image Files Commands; Dhcp Relay Commands; Ethernet Configuration Commands - Dell PowerConnect 6024F Command Line Interface Reference Manual
Command
line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 6024F:
- User manual (474 pages) ,
- Getting started manual (66 pages) ,
- Getting started manual (154 pages)
Table of Contents
Advertisement
show sntp configuration
show sntp status
Configuration and Image Files Commands
Command Group
configure
copy
delete startup-config
boot system
show running-config
show startup-config
show backup-config
show bootvar
DHCP Relay Commands
Command Group
ip dhcp relay enable
ip dhcp relay address
show ip dhcp relay
Ethernet Configuration Commands
Command Group
interface ethernet
interface range ethernet
interface out-of-band-eth
shutdown
description
30
Command Groups
Displays the SNTP configuration
Displays the SNTP status
Description
Enters the global configuration mode.
Copies files from a source to a destination.
Deletes the startup-config file.
Specifies the system image that the device loads at startup.
Displays the contents of the currently running configuration file.
Displays the startup configuration file contents.
Displays the backup configuration file contents.
Displays the active system image file that the device loads at startup.
Description
Enables DHCP relay features on the router.
Defines the DHCP address available for the DHCP relay.
Displays the DHCP relay server addresses.
Description
Enters the interface configuration mode to configure an Ethernet type
interface.
Enters the interface configuration mode to configure multiple
Ethernet type interfaces.
Configures the out-of-band Ethernet port and enter interface
configuration mode.
Disables interfaces.
Adds a description to an interface.
PE
PE
Mode
PE
PE
PE
PE
PE
PE
PE
PE
Mode
GC
GC
PE
Mode
GC
GC
IC
IC
IC
Advertisement
Table of Contents
