Command Mode
Line Configuration (console) mode
User Guidelines
This command is available only on the console line.
Although not saved to the configuration file, the line baud rate setting is permanently saved
until it is explicitly modified.
Examples
The following example configures the line baud rate to 115200.
Console (config)# line console
Console(config-line)# speed 115200
exec-timeout
The exec-timeout line configuration command sets the interval that the system waits until user
input is detected. To restore the default setting, use the no form of this command.
Syntax
exec-timeout minutes [seconds]
no exec-timeout
•
minutes—Integer that specifies the number of minutes. (Range: 0 - 65535)
•
seconds—Additional time intervals in seconds. (Range: 0 - 59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
User Guidelines
To specify no timeout, enter the exec-timeout 0 command.
Examples
The following example configures the interval that the system waits until user input is detected to
20 minutes.
Console (config)# line console
Console(config-line)# exec-timeout 20
202
Line Commands