Arp - Dell PowerConnect 6024F Command Line Interface Reference Manual
Command
line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 6024F:
- User manual (474 pages) ,
- Getting started manual (66 pages) ,
- Getting started manual (154 pages)
Table of Contents
Advertisement
Syntax
show ip interface [ethernet interface-number | vlan vlan-id | port-channel number | out-of-
band-eth oob-interface]]
•
ethernet interface-number—Ethernet port number.
•
vlan vlan-id—VLAN number.
•
port-channel number—Port-channel number.
•
out-of-band-eth oob-interface—Out-of-band Ethernet port number.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays VLAN 1 configuration.
Console# show ip interface vlan 1
arp
The arp global configuration command adds a permanent entry in the Address Resolution Protocol
(ARP) cache. To remove an entry from the ARP cache, use the no form of this command.
Syntax
arp ip_addr hw_addr {ethernet interface-number | vlan vlan-id | port-channel number}
no arp ip_addr {ethernet interface-number | vlan vlan-id | port-channel number}
•
ip_addr—IP address or IP alias to map to the specified MAC address.
•
hw_addr—MAC address to map to the specified IP address or IP alias.
•
ethernet interface-number—Ethernet port number.
•
vlan vlan-id—VLAN number.
•
port-channel number—Port-channel number.
Default Configuration
By default, ARP is disabled.
162
IP Addressing Commands
Advertisement
Table of Contents
