Rmon Commands; Snmp Commands - Dell PowerConnect 6024F Command Line Interface Reference Manual

rip offset
rip default-route offset
rip authentication
show ip rip

RMON Commands

Command Group
show rmon statistics
rmon collection history
show rmon collection history
show rmon history
rmon alarm
show rmon alarm-table
show rmon alarm
rmon event
show rmon events
show rmon log
rmon table-size

SNMP Commands

Command Group
snmp-server community
snmp-server contact
snmp-server location
snmp-server enable traps
snmp-server trap authentication
snmp-server host
snmp-server set
Adds an offset to a metric learned via RIP before adding them to the
interface table.
Generates a default route into RIP .
Enables authentication for RIP Version 2 packets and specifies the
authentication type.
Displays RIP routing information.
Description
Displays RMON Ethernet Statistics.
Enables a Remote Monitoring (RMON) MIB history statistics group
on an interface.
Displays the requested history group configuration.
Displays RMON Ethernet Statistics history.
Configures alarm conditions.
Displays the alarms summary table.
Displays alarm configurations.
Configures a RMON event.
Displays the RMON event table.
Displays the RMON logging table.
Configures the maximum RMON tables sizes.
Description
Sets up the community access string to permit access to SNMP
protocol.
Sets up a system contact.
Sets up the information on where the device is located.
Enables the switch to send SNMP traps or SNMP notifications.
Enables the switch to send SNMP traps when authentication failed.
Specifies the recipient of SNMP notifications.
Sets SNMP MIB value by the CLI.
IC
IC
IC
PE
Mode
UE
IC
UE
UE
GC
UE
UE
GC
UE
UE
GC
Mode
GC
GC
GC
GC
GC
GC
GC
41
Command Groups