Spanning-Tree Link-Type; Spanning-Tree Bpdu - Dell PowerConnect 6024F Command Line Interface Reference Manual

Example
The following example enables PortFast on g5
Console(config)# interface ethernet g5
Console(config-if)# spanning-tree portfast

spanning-tree link-type

The spanning-tree link-type interface configuration command overrides the default link-type
setting. To reset the default, use the no form of this command.
Syntax
spanning-tree link-type {point-to-point | shared}
no spanning-tree spanning-tree link-type
• point-to-point—Specifies the port link type as point-to-point.
• shared—Specifies that the port link type is shared.
Default Configuration
The switch derives the link type of a port from the duplex mode. A full-duplex port is
considered a point-to-point link, and a half-duplex port is considered a shared link.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables shared spanning-tree on g5
Console(config)# interface ethernet g5
Console(config-if)# spanning-tree link-type shared

spanning-tree bpdu

The spanning-tree bpdu global configuration command defines BPDU handling when the
spanning-tree is disabled on an interface.
Syntax
spanning-tree bpdu {filtering | flooding}
• filtering—Filter BPDU packets when spanning-tree is disabled on an interface.
.
.
Spanning-Tree Commands
375