Displaying And Maintaining Mac Address Table Management; Mac Address Table Management Configuration Example - H3C S7500E Series Operation Manual

Operation Manual – MAC Address Table Management
H3C S7500E Series Ethernet Switches
Note:
The maximum number of MAC addresses that can be learned on a port cannot be
applied to the cross-board aggregation group to which the port belongs, that is, the
maximum number of MAC addresses that can be learned on an aggregation group is
not subject to that on a port in the group.
1.3 Displaying and Maintaining MAC Address Table
Management
Display MAC address
table information
Display the aging timer for
dynamic MAC address
entries
Display the system or
interface MAC address
learning state

1.4 MAC Address Table Management Configuration Example

I. Network requirements
Log onto your device from the Console port to configure MAC address table
management as follows:
Set the aging timer to 500 seconds for dynamic MAC address entries.
Add a static entry 00e0-fc35-dc71 for port Ethernet 2/0/1 in VLAN 1.
II. Configuration procedure
# Add a static MAC address entry.
<Sysname> system-view
[Sysname] mac-address static 00e0-fc35-dc71 interface ethernet 2/0/1 vlan 1
# Set the aging timer for dynamic MAC address entries to 500 seconds.
[Sysname] mac-address timer aging 500
To do...
display mac-address blackhole
[ vlan vlan-id ] [ count ]
display mac-address [ mac-address
[ vlan vlan-id ] | [ dynamic | static ]
[ interface interface-type
interface-number ] [ vlan vlan-id ]
[ count ] ]
display mac-address aging-time
display mac-address mac-learning
[ interface-type interface-number ]
Chapter 1 MAC Address Table Management
Use the command...
1-6
Configuration
Remarks
Available in
any view