Before you begin
Nortel IP Audio Conference Phone 2033
The following section provides a step-by-step guide through the IP Audio
Conference Phone 2033 installation process. Before installing the IP Audio
Conference Phone 2033, complete Procedure 47 "Pre-installation checklist"
on
page
321.
Procedure 47
Pre-installation checklist
1
Ensure there is one IP Audio Conference Phone 2033 boxed package for
each IP Audio Conference Phone 2033 being installed. See Table 41 on
page 320
for a list of package contents.
2
To install and configure an IP Audio Conference Phone 2033, the host
system must be installed with the Voice Gateway Media Card.
3
If an AC power adapter is required, ensure the correct AC power
transformer is used. The voltage rating of the transformer must match the
wall outlet voltage. Refer to Table 41 on
4
Understand the three configuration modes you can choose as you
proceed through the installation of the IP Audio Conference Phone 2033.
The three configuration modes are:
•
Static IP address
•
Dynamic Partial DHCP – see "Dynamic IP address assignment —
Partial DHCP" on
•
Dynamic Full DHCP
DHCP" on
5
Make sure a DHCP server and DHCP relay agents, if required, are
installed, configured, and running.
–
see "Static IP address assignment" on
page
322.
–
see "Dynamic IP address assignment — Full
page
323.
End of Procedure
IP Phones
Description, Installation, and Operation
Page 321 of 430
page
320.
page
322.