Procedure 20; Disabling Auto Negotiate And Enabling Full Duplex - Nortel 2001 Installation And Operation Manual

Page 124 of 430
553-3001-368 Standard 7.00
Nortel IP Phone 2004

Procedure 20

Disabling Auto Negotiate and enabling Full Duplex

mode
1 Reset the IP Phone 2004 by disconnecting and reconnecting power.
2 When the Nortel logo appears in the middle of the display, press each of
the soft keys in sequence. See Procedure 19 on
3 If no other configuration changes are required, press OK repeatedly until
the Duplex network option appears.
4 Select 1 to enable Full Duplex mode.
5 When the Speed option appears, select one of the following:
• 0 for 10 Mbps
• 1 for 100 Mbps (default)
6 Select OK to confirm the change.
7 Restart the IP Phone 2004. The firmware reads the new setting, and the
IP Phone operates in Full Duplex mode.
When the IP Phone 2004 is restarted, the firmware reads the setting for
Full Duplex mode and sets both port 0, network interface port, and port 1,
PC interface port, accordingly.
Use the following procedure to confirm activation of Full Duplex mode.
Procedure 21
Checking Ethernet Statistics
1 Double-click the Services key. The Network Diagnostics menu appears.
2 Select Ethernet Statistics.
• If Full Duplex mode is active, the following is displayed:
— Link: UP
— Duplex: Full
— Speed: 10 (Mb) or 100(Mb)
— Auto-Nego Capability: N
— Auto-Nego Completed: N
August 2005
End of Procedure
page 116.