Nortel 2001 Installation And Operation Manual page 159

a. Connect one end of the handset cord to the handset jack on the back
of the IP Phone (identified with a handset icon).
b. Connect the other end of the handset cord to the handset.
4 Choose one of the following connections:
• For an IP Phone not sharing a LAN access with a PC:
Connect one end of the CAT5 Ethernet cable to the LAN Ethernet
port located on the back of the IP Phone (identified with a LAN icon).
Plug the other end of the CAT5 Ethernet cable into the IP network.
• For an IP Phone sharing a LAN access with a PC:
Connect one end of the CAT5 Ethernet cable to the LAN Ethernet
port located on the back of the IP Phone (identified with a LAN icon,
see Figure 15 on
Insert one end of a second CAT5 Ethernet cable into the PC Ethernet
port located on the back of the IP Phone (identified with a PC icon,
see Figure 15 on
port.
CAUTION
Damage to Equipment
Do not plug your IP Phone 2007 into any port but the
PC Ethernet port. Severe damage can result. Consult
your system administrator to ensure that you plug
your IP Phone into the PC Ethernet port.
Timing information
There are only four seconds between plugging in the IP Phone 2007's
power adapter and the appearance of Nortel on the display. When
Nortel appears in the middle of the screen, you have one second to
respond by pressing 0, 0, 7, *. If you miss the one-second response
time, the IP Phone 2007 attempts to locate the connect server. Wait until
it is finished, and then begin the power-up sequence again.
5 Power the IP Phone 2007 using either the Power over Ethernet or the
Global power adapter (local power).
Nortel IP Phone 2007
page 153) and the other end to the IP network.
page 153) and the other end into the PC Ethernet
IMPORTANT!
IP Phones Description, Installation, and Operation
Page 159 of 430