Nortel 2001 Installation And Operation Manual page 43

5 Power the IP Phone 2001 using either the Power over Ethernet or an AC
power transformer (local power).
If local power is used, plug the AC power transformer into the nearest
power outlet. Make sure you use the correct AC power transformer is
used. The voltage rating of the transformer must match the wall outlet
voltage. Refer to Table 4 on
AC power jack shown in Figure 3 on
cord around the retaining hook to provide strain relief for a secure
power connection.
Timing information
There are only four seconds between plugging in the IP Phone 2001
power transformer and the appearance of the Nortel logo in the middle
of the display. When you see the logo, you have one second to respond
by pressing the four feature keys at the bottom of the display in
sequence from left to right. If you miss the one-second response time,
the IP Phone 2001 attempts to locate the connect server. Wait until it is
finished, and then begin the power-up sequence again.
6 When the Nortel logo appears in the middle of the display, immediately
press the four feature keys at the bottom of the display in sequence from
left to right.
7 At the prompt EAP enable?, select Yes. Enter DeviceID and Password.
For more information on EAP, refer to
network access control" on
Note: If you select No, you will not be prompted to enter Device ID and
Password.
8 At the prompt DHCP Yes/No?, select No.
9 Enter the following information provided by your system administrator:
Screen prompt
set IP
net msk
def gw
Nortel IP Phone 2001
page 37. Connect the transformer to the
IMPORTANT!
Appendix C: "802.1x Port-based
page 361
.
Description
A valid IP Phone 2001 IP address
A subnet mask
The default Gateway for the IP Phone 2001 on
the LAN segment to which it is connected
IP Phones Description, Installation, and Operation
Page 43 of 430
page 42. Be sure to thread the