Nortel 2001 Installation And Operation Manual page 240

Page 240 of 430
Table 31
External Lamp Indication tab settings (Part 1 of 2)
Attribute
Manual Override
Headset Disconnect
Active Call
553-3001-368 Standard 7.00
Nortel IP Softphone 2050
To connect the External Lamp to the USB Headset Adapter, plug the External
Lamp cable into the 2.5 mm output jack on the USB Headset Adapter.
Table 31 describes the settings for the External Lamp Indication tab (see
Figure 33 on page 242).
Description
Select one of the cadences to enable the Manual Override feature, or
select None to disable this feature.
When Manual Override is enabled, you can turn on the external lamp
using the Configure IP Softphone 2050 Smart Functions button on
the USB Headset Adapter.
Note: The available cadences are listed at the end of the table.
Select one of the cadences to indicate when the headset is
disconnected from the USB Headset Adapter. Select None to disable
this feature.
Note: The available cadences are listed at the end of the table.
Select one of the cadences to indicate when there is an active call on
the IP Softphone 2050. Select None to disable this feature. If you
select a cadence for Active Call and the USB Headset Adapter is
selected as the Ringing Speaker, the external lamp also indicates when
there is a call ringing on the IP Softphone 2050.
Note 1: If you select the Active Call cadence, the external lamp also
turns on or flashes when another application uses the audio channel for
the USB Headset Adapter.
Note 2: For information about setting the ringing device, refer to
"Select Sound Devices tab" on
Note 3: The available cadences are listed at the end of this table.
August 2005
page 228.