Nortel 2001 Installation And Operation Manual page 108

Page 108 of 430
First-time installation
IP address assignments
553-3001-368 Standard 7.00
Nortel IP Phone 2004
3 If an AC power adapter is required, make sure you use the correct AC
power transformer. The voltage rating of the transformer must match the
wall outlet voltage. Refer to Table 12 on page 106.
4 Understand the three configuration modes that you can choose from as
you proceed through the installation of the IP Phone 2004 . The three
configuration modes are:
• Static IP address
• Dynamic Partial DHCP – see "Dynamic IP address assignment —
Partial DHCP" on
• Dynamic Full DHCP
DHCP" on
5 A DHCP server and DHCP relay agents, if required, must also be
installed, configured, and running.
To install and configure an IP Phone 2004 , you must first install a Voice
Gateway Media Card in the system.
CAUTION
Damage to Equipment
Do not plug your IP Phone 2004 into an ISDN
connection. Severe damage can result. Consult your
system administrator to ensure that you are plugging
your IP Phone into a 10/100BaseT Ethernet jack.
During the first-time installation, there are IP address parameters that are
entered either manually or automatically depending on the installation
configuration. As well, you are prompted to enable or disable 802.1Q. For
more information, see "802.1Q VLAN description" on
The three configuration modes for the IP Phone 2004 are described below.
August 2005
–
see "Static IP address assignment" on
page 109.
–
see "Dynamic IP address assignment — Full
page 109.
End of Procedure
page 109.
page 353.