Nortel 2001 Installation And Operation Manual page 39

Procedure 1
Pre-installation checklist
1 Ensure there is one IP Phone 2001 boxed package for each IP Phone
2001 being installed. The package contains:
• IP Phone 2001
• Handset
• Handset cord
• Footstand
• 2.3 m (7 foot) Cat5 Ethernet cable
• Getting Started card
2 To install and configure an IP Phone 2001, the host system must be
installed with the Voice Gateway Media Card.
3 If an AC power adapter is required, ensure the correct AC power
transformer is used. The voltage rating of the transformer must match the
wall outlet voltage. Refer to Table 4 on page 37.
4 Understand the three configuration modes that you can choose as you
proceed through the installation of the IP Phone 2001. The three
configuration modes are:
• Static IP address
• Dynamic Partial DHCP – see "Dynamic IP address assignment —
Partial DHCP" on
• Dynamic Full DHCP
DHCP" on
5 Make sure that a DHCP server and DHCP relay agents, if required, are
installed, configured, and running.
Nortel IP Phone 2001
–
see "Static IP address assignment" on
page 40.
–
see "Dynamic IP address assignment — Full
page 41.
End of Procedure
IP Phones Description, Installation, and Operation
Page 39 of 430
page 40.